The Structural role of Main Armour Decks

Warship design and construction, terminology, navigation, hydrodynamics, stability, armor schemes, damage control, etc.
Mostlyharmless
Member
Posts: 159
Joined: Wed Jul 22, 2009 10:45 pm

The Structural role of Main Armour Decks

Post by Mostlyharmless » Wed Jun 20, 2018 4:04 pm

Battleships were constructed as a girder of the keel, normally a double bottom, and the main armour deck (MAD). However, different navies constructed the MAD differently.

The USN made their MADs as laminates. Thus, Iowa has a 4.75" upper layer on a 1.25" lower layer of homogeneous armour. Friedman's U.S. Battleships has South Dakota with a 5" upper layer on a 1" lower layer and states that the lower layer was made 1.25" in Iowa as the ship was longer (the upper layer was thicker near its outer edge in both ships and the MAD may not even have been a laminate there in Iowa).

The RN methods were similar with King George V having an upper layer of 200 lb armour over the magazines and 160 lb armour over the machinery with a lower layer of 40 lb armour below.

Italy and Japan also used laminates but the lower layer seems to have been thinner and made of construction steel rather than armour. Thus, the MAD was 150 mm or 100 mm of armour on 12 mm in the Littorio Class and 190 mm (or even 200 mm) of armour on 10 mm of D steel in the Yamato Class.

However, Germany and France did not need to make their MADs as laminates.

Why did the warship designers adopt different methods? Was the armoured weather deck of the Bismarck Class the secret when combined with the 30 mm connection (continuing the 45 mm bulkhead)? If that is true, did Montana's designers miss a trick when proposing two laminates with a 60 lb on 30 lb bomb deck above a 5.8" on 50 lb main deck?

pgollin
Senior Member
Posts: 274
Joined: Sat Jan 11, 2014 12:01 pm

Re: The Structural role of Main Armour Decks

Post by pgollin » Mon Jun 25, 2018 2:56 pm

.

Different navies counted armour as different structural entities, e.g. the USN used the main armour deck as a structural member in both compression and tension, whereas the RN only counted the main armour deck in compression.

.

User avatar
Dave Saxton
Supporter
Posts: 2984
Joined: Sat Nov 27, 2004 9:02 pm
Location: Rocky Mountains USA

Re: The Structural role of Main Armour Decks

Post by Dave Saxton » Tue Jun 26, 2018 3:46 pm

KM Chief Engineer Tobicke described that the German scarp triangle design performed both ballistic and structural functions. The panzer deck and the longitudinal armoured bulkheads essentially comprised a great H beam that the rest of the hull was built from.

Combining both ballistic and structural functions is obviously much more efficient design practice. Taking the armour thickness specs listed above for the Iowa class, for example, the effective thickness of the MAD is not 120mm + 38mm = 158mm. Rather it is the square root of 120mm (squared) + (38mm (squared) = 126mm. The Tirpitz gets about the same total horizontal protection (130mm over the machinery -150mm over the magazines) of the Iowa (140mm inboard with the yaw deck) with a lot less weight expenditure.
Entering a night sea battle is an awesome business.The enveloping darkness, hiding the enemy's.. seems a living thing, malignant and oppressive.Swishing water at the bow and stern mark an inexorable advance toward an unknown destiny.

Post Reply