Warship Shafts

Propulsion systems, machinery, turbines, boilers, propellers, fuel consumption, etc.
User avatar
Legend
Senior Member
Posts: 325
Joined: Tue Oct 21, 2008 12:46 am
Location: Tomahawk, Wisconsin

Warship Shafts

Postby Legend » Sun Dec 26, 2010 8:47 pm

Hey everyone,
Yeah I know, long time no see. I have been busy with school and been playing around with my old designs. Now that I am older I am seeing problems that I couldn't have imagined before.

One of these little quandaries is the fact that my "Armored Citadel" is narrower than the spacing of the outer propellers, or in simpler words the outer props are to the left and right of the "Armored Citadel". The turbines are within this defense network. This means my shafts either have to angled the whole way (resulting in them being angled away from the centerline, and hydrodynamic nightmare?) or have a coupler somewhere inside so they are coming straight out (is a coupler on a big ship a nightmare and potentially a major hazard due to torque?).

All the shafts I have seen, for instance, the Nimitz pictures and Yamato models, appear very straight out of the hull. Also I see many line drawings with the shafts heading DOWNWARD from the hull... that isnt relevant to my horizontal spacing issue... but it is a curious design.

Best Regards,
Matthew Petrie
AND THE SEA SHALL GRANT EACH MAN NEW HOPE, AS SLEEP BRINGS DREAMS.

alecsandros
Senior Member
Posts: 3990
Joined: Wed Oct 14, 2009 2:33 pm
Location: Bucharest, Romania
Contact:

Re: Warship Shafts

Postby alecsandros » Mon Dec 19, 2011 9:45 pm

They were straigth, AFAIK.
Not all the shafts originated ffrom the same general area. In Bismarck for instance, the center shaft was shorter than the other 2, as it was connected to the turbine in Section VIII.The port and starboard shafts were connected to turbines in Section X.
You can see it better scrolling down this page: http://www.kbismarck.com/propulsioni.html

User avatar
marcelo_malara
Senior Member
Posts: 1072
Joined: Sun Oct 02, 2005 11:14 pm
Location: buenos aires

Re: Warship Shafts

Postby marcelo_malara » Wed Apr 11, 2012 4:16 pm

The Bismarck shafts are angled to the ship centreline, I don´t remember the exact angle now.

Regards

Thorsten Wahl
Senior Member
Posts: 643
Joined: Mon Apr 27, 2009 4:17 pm

Re: Warship Shafts

Postby Thorsten Wahl » Fri Apr 13, 2012 12:35 am

ca. 2,5 degrees downward
outer shafts ca 1,5 degrees outward
Meine Herren, es kann ein siebenjähriger, es kann ein dreißigjähriger Krieg werden – und wehe dem, der zuerst die Lunte in das Pulverfaß schleudert!


Return to “Naval Propulsion”

Who is online

Users browsing this forum: No registered users and 2 guests